Camping Knots

How to tie a knot on a line?

Pick a knot by its job: a bowline for a fixed loop, two half hitches for a post, and a sheet bend to join ropes. Includes steps and a fishing-line note.

On this page
  1. The short answer
  2. Pick the knot by the job
  3. Tie a bowline
  4. Tie two half hitches
  5. Join two lines
  6. Fishing line
  7. Check the knot before you trust it

The short answer

It depends on the job. Tie a bowline to make a fixed loop at the end of a line. Tie two half hitches to fasten a line to a post, tree, or ring. To join two lines, use a sheet bend when the lines differ in thickness. Use a reef knot only when the lines match and the load is light.

Pick the knot by the job

Job Knot Steps
Fixed loop at the end of a line Bowline Below
Fasten a line to a post, tree, or ring Two half hitches Below
Adjustable tension on a guyline Taut-line hitch Clothesline knots
Join two lines of the same thickness Reef (square) knot Survival knots
Join two lines of different thickness Sheet bend Survival knots

Tie a bowline

  1. Make a small loop near the end of the line.
  2. Pass the tail up through the loop, from underneath.
  3. Wrap the tail around the back of the standing line.
  4. Feed the tail back down through the small loop.
  5. Pull the standing line and the tail in opposite directions to tighten.

Tie two half hitches

Use this for a post, a tree, or a ring. For a heavier load, first take one full turn around the post (a round turn).

  1. Pass the end around the post.
  2. Tie a half hitch around the standing line.
  3. Tie a second half hitch next to the first.
  4. Pull to tighten.

Join two lines

Sheet bend (different thicknesses). Make a bight, a U-shaped loop, in the thicker line. Pass the thinner line up through the bight, around behind both parts of it, and tuck it under its own standing part. Pull both lines to tighten.

Reef knot (similar thicknesses). Cross the two ends and tie an overhand knot. Then cross the ends the other way and tie a second overhand knot.

Be careful with the reef knot. It can slip or capsize with slippery or unequal lines. Use it for bundles and light jobs only, and never where a failure could hurt someone.

Fishing line

Fishing line is thinner and more slippery than rope, so anglers use different knots. For a hook, the improved clinch knot and the Palomar knot are common choices. Wet the line before you pull a fishing knot tight, because tightening it dry can damage the line.

Check the knot before you trust it

  • Tie the knot with the load in place, where you can.
  • Leave a tail of several inches past the knot.
  • Look at the knot and pull on it. Check it again after the line has been loaded or wet.

For more knots, see survival knots and clove hitch.

The complete guide to camping knots

Camping Knots: Essential Knots for Tents and Campsites
Read the guide

Keep exploring

Guides from other topics

All topics →