Camping Knots

Clove Hitch: How to Tie It Around a Pole, Post or Tree

Learn how to tie a clove hitch around a pole, post, or tree, plus an open-end method, how to stop it slipping, and when to pick a different knot.

On this page
  1. The short answer
  2. Method 1: from the end of the line
  3. Method 2: two loops for an open post or carabiner
  4. Keep it from slipping
  5. When to use a different knot

The short answer

A clove hitch holds a line to a post, pole, or tree. Wrap the line around the post twice, crossing over the standing line on the second wrap. Tuck the end under that second wrap, then pull both ends to tighten. It is quick to tie and easy to undo, but it can slip under changing loads. Finish it with half hitches for anything that matters.

Method 1: from the end of the line

Use this on a closed post, rail, or tree, where you cannot slide a loop over the top.

  1. Make the first wrap. Drape the working end over the top of the post and bring it back underneath.
  2. Cross over the standing line. Bring the working end up and across the main line at a diagonal, forming an X.
  3. Make the second wrap. Take the working end around the post a second time, in the same direction.
  4. Tuck the end. Slide the working end under the second wrap, keeping it parallel to the wraps.
  5. Tighten. Pull both ends at once to snug the wraps against the post.

Method 2: two loops for an open post or carabiner

Use this when you can drop the hitch over the open end of a stake or post, or clip it into a carabiner.

  1. Make the first loop. Make a loop in the line, passing the working end behind the standing line.
  2. Make the second loop. Make an identical loop beside the first, again passing the working end behind the standing line.
  3. Stack the loops. Slide the second loop behind the first, without flipping either loop over.
  4. Drop and tighten. Place the loops over the post, or clip a carabiner through both. Pull both ends tight.

Keep it from slipping

  • Finish with half hitches. For permanent or heavy loads, add one or two half hitches around the standing line.
  • Leave a long tail. Keep about 4 to 6 inches of spare line past the knot, so the tail cannot pull back through.
  • Check it after loading. A clove hitch can loosen if the line twists or the post moves. Re-check it after the first load.

When to use a different knot

A clove hitch on its own is not suitable for climbing or for any load where a slip could cause injury. For those jobs, use the correct knots and equipment taught in proper training.

  • For a fixed loop at the end of a line, use a bowline.
  • For tension you may need to adjust later, use a taut-line hitch.
  • For a pull along the length of a pole or another rope, a rolling hitch grips better.
  • For binding a bundle or a bag neck tight, the constrictor knot adds one extra pass to the clove hitch and grips much harder.
  • For a line around a living tree, read tree-friendly knots, which covers wide straps and bark protection.

For more camp knots, see the camping knots guide.

The complete guide to camping knots

Camping Knots: Essential Knots for Tents and Campsites
Read the guide

Keep exploring

Guides from other topics

All topics →