The short answer
Use a bowline at each grommet or loop, a taut-line hitch on each guyline so you can adjust the tension, and two half hitches to finish at a tree or post. For a tight ridgeline, a trucker’s hitch helps, but it takes practice.
What to tie to
Tarps usually have reinforced holes, called grommets, at the corners and along the edges. They also tie to trees, stakes, poles, and trekking poles. Match the knot to the attachment:
- Grommet: a bowline, or a simple loop.
- Guyline you want to adjust: a taut-line hitch.
- Tree or post: a clove hitch, or two half hitches.
Grommets: the bowline
A bowline makes a fixed loop that does not slip or jam under load, and it unties easily afterward. It is a good choice for a grommet, where you may want to pull the tarp down later. The survival knots guide gives the steps.
Guylines: the taut-line hitch
A taut-line hitch slides when it is loose and grips when it takes a load, so you can set tension and keep it there.
- Wrap the working end around the stake or tree.
- Make two turns around the guyline, on the anchor side.
- Make one more wrap around the guyline, outside those turns, and pull to lock it.
- Pull the tail to snug the hitch, then slide the hitch along the line to adjust.
Practice this at home with a spare cord before you need it in the dark.
Ridgelines: the trucker’s hitch
A trucker’s hitch uses a loop and a pulled section of line to multiply your pull, then locks with half hitches. It is the usual way to get a ridgeline properly tight. It takes practice to tie cleanly, so learn it on a spare line first. Pull the line taut but not so hard that it strains the grommets or the anchor points.
Tie-offs: two half hitches
Wrap the line around the post or tree, then tie one half hitch around the standing part of the line and a second one beside it. It is quick and easy to undo.
What is the best way to secure a tarp?
For most pitches, a bowline at the grommet, a taut-line hitch on the guyline, and two half hitches at the tie-off do the job. Tie the main anchor points first, then the corners, then the guylines. Tension the lines last, and check the tarp’s shape.
Wet weather and wind
Cord stretches when it is wet, and knots can change shape. After a gust or a rain shower, check the tension on every guyline and retension where needed. Do not overtighten grommets. A sharp pull on a grommet can tear the tarp, and a tight line can pull a stake out of soft ground.
Common mistakes
- Pulling a grommet at a sharp angle, which can tear the fabric.
- Anchors that are too low, so the tarp sags and collects water.
- Overtightening, which pulls stakes and fixings loose.
- Knots you cannot undo after a load. Choose hitches that release when you need them to.
For the basics that apply to every pitch, read the camping knots guide for tents and campsites. If you want to tie a tarp over a hammock, the hammock knots guide covers the tree end.