Fishing Knots

Improved Clinch Knot: How to Tie It Step by Step

Tie the improved clinch knot step by step for mono and fluorocarbon. Covers wrap counts by line size, common mistakes, and when to choose another knot.

On this page
  1. Where it works, and where it does not
  2. What you need
  3. Step by step
  4. Wrap counts by line size
  5. Common mistakes
  6. A naming note

The improved clinch is a classic knot for tying mono or fluorocarbon to a hook, lure or swivel. It is a variation of the basic clinch knot with an extra pass through the loop, which adds security. It works best on light to medium line.

Where it works, and where it does not

  • Works well on: monofilament and fluorocarbon, with hooks, lures and swivels.
  • Not ideal for: lines over about 30 lb breaking strength. One guide advises against it for heavier line, and says it can be tricky to tie.
  • Braid: many guides say it is hard to tie well on slick braid. For braid, the Palomar knot is a common choice.

What you need

  • Your line, with about 6 to 10 inches of tag end.
  • A hook, lure or swivel.
  • Water or saliva to wet the knot.
  • Clippers to trim the tag.

Step by step

  1. Thread the eye. Pass the tag end of your line through the eye of the hook, lure or swivel. Leave 6 to 10 inches of tag.
  2. Wrap the standing line. Wrap the tag end around the standing line 5 to 7 times. Keep the coils close and neat, without overlapping. Use fewer wraps for heavier line and more for lighter line (see the table below).
  3. Pass through the small loop. Pass the tag end through the small loop formed right beside the eye.
  4. Pass through the big loop. Bring the tag end back up and pass it through the large loop you just made. This second pass is what makes it an “improved” clinch.
  5. Wet and cinch. Moisten the knot. Pull the standing line and the tag end steadily, so the coils slide down against the eye.
  6. Trim. Cut the tag end, leaving a small tail of about 1/8 to 1/4 inch.

Wrap counts by line size

Line Wraps
Heavier line 4 to 5
Standard mono or fluorocarbon 5 to 7
Lighter line 7 to 8

Sources vary a little on these ranges. Start with the middle of the range for your line, then test the knot.

Common mistakes

  • Loose wraps. Each coil should sit tight against the last.
  • Crossed coils. They weaken the knot and can jam.
  • Cinching dry line. Wet the knot first to reduce friction and heat.
  • Pulling one end only. Pull the standing line and the tag evenly.
  • Skipping the test. Give the finished knot a firm tug before you fish.

A naming note

Some guides call the improved clinch the “fisherman’s knot.” That name is also used for a different knot, the double overhand, which joins two lines. Check which knot the guide shows before you tie it. For other knots that suit hooks and lures, see our strongest monofilament knots guide.

The complete guide to fishing knots

Fishing Knots for Braided Line: The Best and Strongest Options
Read the guide

Keep exploring

Guides from other topics

All topics →