The short answer
Wrap the end of the line around the pole and finish with two half hitches. If the pole has an eye, hook, or ring, pass a bowline through it instead. At the far end, use a taut-line hitch so you can tighten the line.
Plain pole: round turn and two half hitches
- Pass the end of the line once around the pole.
- Bring the end back across the standing line, and tie a half hitch around it.
- Tie a second half hitch next to the first.
- Pull both ends to snug the knot against the pole.
Pole with an eye, hook, or ring: bowline
Tie a bowline in the end of the line, leaving a loop that will go through the eye or over the hook. Pass the loop through, then pull the standing line and the tail to tighten.
Tighten the far end
Tie a taut-line hitch at the far end of the line so you can slide it to adjust the tension. The steps are in the clothesline knots guide. Pull until the line has only a gentle sag. A line pulled very tight strains the poles and the fixings. Some people use a commercial washing-line tightener instead. If you do, follow the maker’s instructions.
Safety
- Check the pole first. It should be set firmly in the ground or fixed to a solid base. A wobbly pole will lean as you tighten.
- Look for damage. Check the pole and its fixings for splits, rot, or rust.
- Keep the line high and clear. Hang it above head height, and keep it clear of overhead power cables.
- Re-check after strong wind. Strong gusts can loosen knots and fixings.
Related reading
- Clothesline knots for a fuller guide to tensioning.
- Tree-friendly knots if you need to tie to a tree instead of a pole.
- Camping knots for tents and campsites for the wider picture.