The short answer
For most hangs, tie a bowline or use a loop-and-tail hitch at each end, and protect the trees with wide straps. Follow your hammock maker’s guide for spacing and height. Test the hang with weight before you trust it.
Before you hang
- Pick live, sturdy trees. Look up for dead or hanging branches. Avoid trees with rot, cracks, or fungus at the base.
- Check the spacing. Many hammock makers suggest trees roughly 12 to 15 feet (about 4 to 4.5 m) apart. Spacing depends on the length of your hammock, so use its own guide.
- Check your gear. Look for fraying, UV damage, stiff or cracked webbing, and worn stitching. Replace anything doubtful.
Method A: straps and carabiners
Many strap sets end in a carabiner that clips to the hammock. The usual connection is a loop-and-tail hitch:
- Pass the strap down through the carabiner, toward the ground.
- Bring the tail back over the top of the carabiner.
- Make a small loop with the tail, pass the loop up through the carabiner and under the first loop.
- Pull the tail to snug the hitch. To release it, pull the tail.
Check this method against your strap maker’s instructions, because straps vary. Test the hang with your weight, low to the ground, before you sleep in it.
Method B: rope to trees
- Wrap the rope or strap around the tree with a round turn: one full turn, with the line crossing over itself.
- Finish with two half hitches around the standing part of the rope.
- Attach the hammock end with a bowline loop, or with the carabiner method above.
- Pull everything snug. Do not cinch it so tight that it cuts into the bark.
A bowline is the knot to learn first for this method. The survival knots guide shows the steps in full.
Tension and height
Pull the hammock to a comfortable lie, with both ends at about the same height. Keep it low enough that you can get in and out safely. A taut-line hitch on a rope line lets you adjust the tension later without re-tying.
Common mistakes
- Thin cord that cuts into bark. Use a wide strap. Read the tree-friendly knots guide before you tie to a tree.
- Hanging too low over hard ground, or too high to step in safely.
- Uneven tie-offs that pull the hammock to one side.
- Skipping the test. Put your weight on the hang before you settle in.
Checks before each night
- Look over the knots and straps for fraying, wear, or loosening.
- Check that the trees have not moved and that there are no loose limbs overhead.
- Do not exceed the rated weight of your hammock or straps.
- Keep the hammock away from fires, rocks, and hard ground.
If you plan to sleep in your hammock every night, see Is it healthy to sleep in a hammock every night? for what is and is not known about that.
For the wider picture of camp knots, see the camping knots guide for tents and campsites.