Fishing Knots

Palomar Knot: Step-by-Step Guide for Braid and Mono

Learn to tie the Palomar knot for braid and mono step by step, with tips on wetting, cinching and trimming, plus the common mistakes to avoid.

On this page
  1. What the Palomar is for
  2. What you need
  3. Step by step
  4. Two ways to cinch the knot
  5. Braid and mono
  6. Common mistakes
  7. Check the knot before you fish

The Palomar is a simple knot for tying line to a hook, lure or swivel. It works with braid, mono and fluorocarbon, and many anglers learn it first.

What the Palomar is for

Use the Palomar to attach a hook, lure or swivel directly to your line. It is not a line-to-line knot. To join two lines, see braid to leader knots.

What you need

  • Enough line to double about 6 to 12 inches, plus a tag end.
  • A hook, lure or swivel with an eye large enough to pass the loop through.
  • Water or saliva to wet the knot.
  • Clippers to trim the tag.

Step by step

  1. Double the line. Fold about 6 to 12 inches of line into a loop.
  2. Pass the loop through the eye. Push the folded loop through the eye of the hook, lure or swivel. Keep the two strands from crossing or twisting.
  3. Tie a loose overhand knot. With the doubled loop, tie a simple overhand knot around the standing line and the tag end. Do not pull it tight yet, and keep the hook hanging outside the loop.
  4. Pass the hook through the loop. Open the loop wide and pass the whole hook, lure or swivel through it.
  5. Wet the knot. Use saliva or water. Wet line creates less friction and heat as you tighten.
  6. Cinch. Pull the standing line and the tag end slowly and evenly until the knot is snug. The section below explains where the knot should sit.
  7. Trim. Cut the tag end, leaving about 1/8 to 1/4 inch.

Two ways to cinch the knot

Guides differ on where the final knot should sit. Some slide it up against the eye. Animated Knots, a widely used reference, describes tightening the loop around the line below the eye, which lets the hook turn freely, and says most experienced anglers prefer that version. Either way, pull evenly and test before you fish.

Braid and mono

  • Braid is slick and thin. Cinch it slowly and check that every coil sits neatly before you trim.
  • Mono can heat and weaken if it is pulled dry. Wet it first and cinch steadily.

Common mistakes

  • Crossed or twisted strands going through the eye.
  • Tying with dry line, which adds friction and heat.
  • Skipping the hook pass. The hook has to go fully through the loop for the knot to form properly.
  • Pulling one end only, which leaves the knot lopsided.
  • Trimming the tag too close, so it can slip out.

Check the knot before you fish

Pull the standing line and the tag end firmly. Look for crossed or uneven coils. If anything slides or looks wrong, retie it. For a lure that is too large for the loop, the uni knot is a common alternative, and our guide to how to tie the strongest fishing knot covers when to switch.

The complete guide to fishing knots

Fishing Knots for Braided Line: The Best and Strongest Options
Read the guide

Keep exploring

Guides from other topics

All topics →