The short answer
Six knots and one lashing cover most jobs at camp. Learn them first, practise them at home until you can tie them without thinking, and check every knot before you rely on it. The knot you can tie with cold fingers in the dark is worth more than one you half remember.
Knot words to know
- Working end: the end you tie with.
- Standing end (standing part): the long part you do not tie with.
- Bight: a U-shaped fold in a line.
- Hitch: a knot that ties a line to something, such as a post, tree, or ring.
- Bend: a knot that joins two lines.
- Lashing: a binding that holds two or more poles or sticks together.
The six knots
Bowline: a fixed loop that will not slip
Use it for a fixed loop at the end of a line, or to tie to a tree, post, or ring. It holds under load but unties easily afterwards.
- Make a small loop near the end of the line.
- Pass the tail up through the loop, from underneath.
- Wrap the tail around the back of the standing line.
- Feed the tail back down through the small loop.
- Pull the standing line and the tail to tighten.
Clove hitch: a quick hitch to a post
Use it to start a lashing, or for a temporary hitch to a pole. Wrap the line around the post twice, crossing over the standing line on the second wrap, then tuck the end under. The clove hitch guide covers two methods.
Two half hitches: a fast tie-down
Pass the end around the post or ring, tie a half hitch around the standing line, then tie a second half hitch next to it. Pull tight. For a heavier load, take one full turn around the post first (a round turn).
Taut-line hitch: an adjustable hitch
Use it on guylines and tarp ridgelines, where you may need to change the tension later. Wrap the tail around the anchor, take two wraps around the line toward the anchor, then make one more wrap on the outside. Pull to lock, then slide the hitch to adjust. For tarps, see tarp knots.
Sheet bend: joining two different lines
Make a bight in the thicker line. Pass the thinner line up through the bight, around behind both parts of it, and tuck it under its own standing part. Pull both lines to tighten. It suits lines of different thickness. The sheet bend guide covers the double sheet bend for slippery line.
Reef (square) knot: joining two similar lines
Cross the two ends, tie an overhand knot, then cross the ends the other way and tie a second overhand knot. Use it for bundles and light jobs with two lines of similar thickness. See the square knot guide for the full steps.
Caution: a reef knot can slip or capsize with slippery or unequal lines. Do not use it for anything where a failure could hurt someone.
The lashing: square lashing for poles
A square lashing joins two poles at a right angle. Start with a clove hitch on one pole, wrap the cord around both poles three to four times, add three to four frapping turns between them, and finish with a clove hitch. For steps and tips, see how do I tie two sticks together perpendicularly?.
Practise and check
- Practise at home with a piece of cord. Tie each knot several times in a row.
- Check each knot by looking at it and pulling on it before you rely on it.
- Re-check knots after the rope has been wet or loaded, because some knots loosen.
Safety limits
- Every knot weakens rope, so do not assume a knotted line is as strong as the rope’s rating.
- These are camp knots. Do not rely on them for climbing, rescue, or any load where a failure could cause serious injury. Use proper training and certified equipment for those.
- Keep cooking fires well clear of any lashed frame or tripod.
Related reading
- Camping knots for tents and campsites for knots by camp task.
- Lashing knots for more lashing types.
- Bear bag hang for a camp task that uses a clove hitch and a bowline.