The short answer
A loop slips when it is a running knot, one that can slide along the rope. To get a loop that stays the same size, tie a fixed loop, such as a bowline or figure eight loop, and dress it before you load it. For a fishing lure or fly, tie a non-slip loop, which holds its size and lets the lure move freely.
Fixed loops for rope work
A fixed loop keeps its size because it has no running end. Common choices include:
- Bowline: a classic fixed loop. See the bowline guide for steps and checks.
- Figure eight loop: a simple fixed loop. The figure eight follow-through is a common climbing version, with a retrace that makes it easier to check.
- Alpine butterfly: a loop tied in the middle of a rope. See the alpine butterfly knot.
Non-slip loop for fishing
Use this loop for lures and flies. The knot stays put while the eye lets the bait move.
- Tie a loose overhand knot a few inches from the end of the line. Do not tighten it yet.
- Pass the tag end, the short end, through the eye of the hook, lure, or fly.
- Pass the tag end back through the overhand knot, so it runs through the loop.
- Pull the tag end to set the loop size. Keep the loop small so the hook shank does not catch in it.
- Wrap the tag end around the main line three to five times. Use fewer wraps on thick line and more on thin line.
- Pass the tag end back through the opening of the overhand knot.
- Moisten the knot with water or saliva. Pull the main line and the tag end in opposite directions to cinch the wraps tight against the eye.
- Trim the tag end close to the knot.
Check the finished knot. The wraps should lie side by side, not stacked, and the knot should sit snug against the eye. If it looks different from a clear diagram, untie it and start again. For other fishing loops, such as the uni loop and the perfection loop, see fishing loop knots.
Why loops slip
- A running knot. A slipknot slides by design. Use a fixed loop when the loop must hold its size.
- A loose or unset knot. Dress and set the knot before you load it. A loose knot can change shape.
- A short tail. A short tail can pull through if the knot shifts.
- Changing loads. Loads that come and go can loosen a knot, so check it after the first loads.
Checks before use
- Pull on the standing part. The loop should keep its size.
- The knot should have no twists and should look neat and set.
- The tails should be long enough to see.
- For anything that bears weight, have a partner check the knot.
Safety and limits
Loops used for climbing, rescue, or rigging carry life-safety risk. Learn those knots from a qualified instructor, and follow the gear maker’s guidance. A written guide is a starting point, not training.
Related knots
- Loop knots covers the main loop types and their uses.
- What is a loop knot used for? compares fixed, running, and non-slip loops.