Loops and Bends

Figure Eight Follow-Through: How to Tie and Check It for Climbing

Learn how to tie a figure eight follow-through for climbing, from the tie-in steps to the checks a partner should make before every single climb.

On this page
  1. What it is
  2. How to tie it
  3. Check the knot
  4. Common mistakes
  5. Safety and limits
  6. Related knots

What it is

The figure eight follow-through is a common climbing tie-in. You tie a figure eight in the rope, thread the tail through your harness, and then retrace the figure eight with the tail. The retrace leaves strands that run parallel to each other, which makes the knot easier to check. It is also called the rethreaded figure eight.

This is a life-safety knot. Learn it from a certified instructor, follow your harness maker’s tie-in instructions, and have a partner check it before every climb.

How to tie it

  1. Leave a tail. Measure out a long tail from the working end of the rope. Use at least the length your instructor teaches.
  2. Tie a loose figure eight. Form a loop, wrap the tail around the standing part, and feed it back through the loop to make the figure-eight shape. Leave the knot loose.
  3. Thread the tail through the harness. Pass the tail through the tie-in points your harness requires, usually the waist belt and both leg loops. Follow your harness maker’s instructions, and pull the knot up close to the harness.
  4. Follow through. Trace the figure eight back with the tail, following the same path through every part of the knot, so the tail lies parallel to the original strands.
  5. Dress and set. Smooth the knot so that no strands cross or twist where they should not. Pull each strand to tighten the knot. Compare it with a known good figure eight.

Check the knot

Check these with your partner before every climb:

  • Each strand runs parallel to the strand it follows, with no crossing errors or twists.
  • The knot matches a known good figure eight follow-through.
  • The tail is at least as long as your instructor and gear guide require.
  • The tail goes through every tie-in point the harness requires.
  • The knot is dressed, neat, and set.

Common mistakes

  • Missing a tie-in point, or threading the tail through the wrong one.
  • Retracing a different path, which gives a knot that is not a true follow-through.
  • A tail that is too short.
  • Strands that twist or cross.
  • Not checking the knot after a hard fall.

Safety and limits

  • Learn the tie-in and the check with a qualified instructor before you climb on your own.
  • Follow your harness maker’s tie-in instructions. Harness designs differ.
  • Inspect the rope and the knot before each climb, and retire damaged rope.
  • The bowline is a fixed loop that many climbers compare with the figure eight.
  • The Yosemite bowline adds a finishing tuck to the bowline. Climbers and instructors disagree about bowline variants, so ask your instructor which one they teach.
  • Loop knots covers the main loop types.

The complete guide to loops and bends

Loop Knots: How to Tie Secure Loops for Climbing and Boating
Read the guide

Keep exploring

Guides from other topics

All topics →