What the Yosemite finish adds
The Yosemite finish is an extra step added to a standard bowline. It is often described as a way to keep the bowline from capsizing, and to route the tail out of the way so it is not caught by accident. It changes the finish of the knot, not the basic bowline.
Before you start
- Learn the standard bowline first. The finish only makes sense on a bowline you can already tie reliably.
- Leave a longer tail than you would for a plain bowline, so there is room for the finish.
- Use a rope that is easy to see, so you can check each strand as you go.
Steps
Tie the standard bowline
Tie a standard bowline as usual, but leave the working end long enough for the finish.
Route the working end for the finish
Take the working end outside the main loop, then back into the centre of the knot so it runs alongside the standing part. The exact path matters, and it is easy to get wrong from a written description. Follow a clear diagram or video that shows the finish from more than one angle, and practise on a spare rope.
Dress in the right order
Dressing the knot in the wrong order is a common problem.
- Snug the base bowline first. Pull the standing part and the main loop until the bowline is set.
- Then snug the finish. Pull the finish down against the knot.
Pulling the working end first can distort the knot into an unsafe shape, so keep this order.
Check the result
- Each strand should lie flat beside its partner.
- No strands should cross or twist where they should lie parallel.
- The tail should be long enough to see and grip.
Checking the knot
- Compare the finished knot with a known-good Yosemite bowline. An instructor’s example is best.
- Ask a partner to check it before you rely on it.
- Inspect the knot after falls or heavy loads. If you are unsure of its shape, untie it and start again.
Yosemite bowline or figure eight?
Climbers disagree about this. Some prefer the Yosemite finish because it keeps the tail out of the way, and some report it is easier to untie after loading. Others prefer the figure eight follow-through because it is simpler to check by eye and is a common tie-in knot. Climbing forums show both views, along with debate over other bowline variants.
Use the tie-in knot your climbing course or guide teaches, and do not switch to a variant you have not practised.
Safety
- Bowlines and their variants can loosen or capsize, so inspection matters.
- Do not use the Yosemite finish for life safety unless you have been taught it and a knowledgeable person has checked your knot.
- For more on the base knot and its limits, see the bowline guide.