Loops and Bends

Water Knot: How to Join Webbing and Flat Straps

Tie a water knot to join webbing or flat straps, leave tails of the right length, check for creep, and learn when to retie or replace the strap.

On this page
  1. What it is
  2. How to tie it
  3. How long to leave the tails
  4. Creep and retying
  5. When to replace webbing
  6. Safety and limits
  7. Where it fits
  8. Related knots

What it is

The water knot, also called a tape knot or ring bend, joins two pieces of flat webbing or tape. It can also make a continuous loop from one piece. People use it for tie-downs, straps, and gear repair.

How to tie it

  1. Lay out the webbing. Lay both pieces flat and untwisted. To make a loop, use the two ends of one piece.
  2. Tie a loose overhand knot. In one piece, tie a loose overhand knot, leaving a tail. Do not tighten it yet.
  3. Retrace the path. Take the other piece’s end and follow the path of the overhand knot, going through the same openings in the same order, so the two pieces lie side by side.
  4. Keep it flat. Make sure the strands run parallel and flat, with no twists.
  5. Dress and set. Pull all the strands snug. Then load the knot firmly to set it before you use it.

How long to leave the tails

Common guidance is to leave tails of at least 2 to 3 inches (about 5 to 7.5 cm). Use longer tails for heavy or critical loads, and follow the webbing maker’s guidance.

Creep and retying

A water knot can creep, or loosen slightly, when it is loaded and unloaded over time. Check the knot and the tails before each use. If a tail has pulled in, or the knot has shifted, untie it and tie it again.

When to replace webbing

Retire webbing that is frayed, cut, burned, or damaged by chemicals. A knot also weakens webbing, so check the maker’s guidance for any rating before you use a knotted strap for a load.

Safety and limits

  • Knots reduce the strength of webbing. Check the maker’s guidance before you use a knotted strap for any load.
  • For climbing anchors, slings, and other life-safety uses, follow your training and the gear maker’s rules. Many climbers use factory-sewn slings where a tested sling is needed.
  • Check the knot before each use.

Where it fits

  • Joining two straps for a tie-down or cargo strap.
  • Making a continuous loop from one strap.
  • Temporarily joining cut or torn webbing, until it can be repaired or replaced.

The complete guide to loops and bends

Loop Knots: How to Tie Secure Loops for Climbing and Boating
Read the guide

Keep exploring

Guides from other topics

All topics →