What it is
A bowline on a bight is a bowline made from a bight, a doubled section of rope, rather than from the rope’s end. The finished knot has two fixed loops in one rope.
This page explains how the knot is built and how to check it. It does not give a numbered tying sequence. Learn the standard bowline first, then learn this version from a clear diagram or an instructor.
When it is used
- When you need two fixed loops from the middle of one rope.
- When you want to attach two points to one rope.
- In rope work where a fixed loop is needed away from the end of the line.
How it is built
The knot follows the same plan as a standard bowline. The difference is that a bight takes the place of the working end, so the finished knot has two loops instead of one.
Because the two loops are formed together, check that both are the size you want before you set the knot.
Check the knot
- Both loops hold their size when you pull on the standing part.
- Neither loop is twisted or pinched.
- The knot is set, with no slack in the loops.
- The finished knot matches a clear diagram from a reliable source. If it does not, untie it and start again.
Safety and limits
- Rope rescue, and any work that lifts or holds a person, needs training from a qualified instructor.
- Do not assume that the two loops share the load evenly. Check the knot carefully before you use it.
- A bowline can loosen or capsize under shock loads or side loads. Inspect it before each use.
- For critical use, many instructors recommend a backup knot or a different knot.
Related knots
- The bowline is the standard knot that the bight version is built on.
- The Yosemite bowline is a bowline with an extra finishing tuck.
- Loop knots covers loops in general.