Knot Basics

Overhand Knot: How to Tie the Basic Stopper Knot

Learn how to tie an overhand knot, the simplest stopper knot, with step-by-step instructions, common uses, and when it jams under load.

On this page
  1. How to tie an overhand knot
  2. What the overhand is used for
  3. When the overhand fails
  4. Common mistakes
  5. Frequently asked questions

The overhand knot is a simple single-strand knot. You cross the rope over itself and pass the end through the loop. It is also called a thumb knot or half knot, and it is the simplest stopper knot. A single overhand can jam under heavy load, so for a stopper that will take a load, a figure-eight is usually the better choice.

How to tie an overhand knot

  1. Make a loop. Cross the working end over the standing part to form a small loop.
  2. Tuck the working end. Pass the working end under and up through the loop, from behind.
  3. Tighten. Pull the working end and the standing part in opposite directions until the knot is snug.

Leave a tail of a few inches. A very short tail can slip free.

What the overhand is used for

  • A stopper at the end of a cord. It stops the cord from slipping through a hole, a grommet, or a bead. It does not stop the end fraying, which needs whipping or another finish.
  • The start of other knots. The figure-eight uses the same idea with one extra turn.
  • A loop, when tied on a bight. Tying the knot with a doubled-over section of rope, instead of the end, makes a loop. This is called an overhand on a bight.

When the overhand fails

  • Under heavy load, a single overhand can pull tight and jam, so it is hard to untie.
  • Wet or slippery cord makes slipping and jamming more likely.
  • It is a small stopper. For a bulkier stopper that is easier to inspect and untie after a load, use a figure-eight. See our rope knot types guide for the other families.

Common mistakes

  • Leaving no tail. The end can work free, so keep a few inches.
  • Tying it loosely. Pull both parts firmly so the knot keeps its shape.
  • Using it to join two ropes. A single overhand does not join ropes. Use a bend instead, such as the sheet bend, as explained in our rope knot types guide.

Frequently asked questions

Is the overhand knot the same as a half knot?

Yes, the terms are often used for the same knot. A single overhand is also called a thumb knot. Tying a second overhand on top of it gives a double overhand, which is a different and bulkier knot.

Why does my overhand keep slipping?

It is usually because the tail is too short, the knot is loose, or the cord is slick. Tighten it firmly, leave a longer tail, or add a figure-eight for a more secure stopper. For why knots hold and jam, see how knots work.

The complete guide to knot basics

Best Knots to Learn: A Beginner's Guide to Knot Tying
Read the guide

Keep exploring

Guides from other topics

All topics →