The short answer
In knot tying, a rabbit hole is a memory story for tying a bowline. The small loop you make is the hole. The working end of the rope is the rabbit. The standing part, the long part that carries the load, is the tree. The rabbit comes up out of the hole, goes around the tree, and goes back down the hole.
The three parts of the story
- The hole: a small loop made in the rope.
- The rabbit: the working end, the free end of the rope.
- The tree: the standing part, the long part of the rope that carries the load.
The story in four moves
- The rabbit comes up out of the hole, from underneath.
- The rabbit goes around the back of the tree.
- The rabbit goes back down the hole.
- Set the knot by pulling on the standing part while you hold the hole and the rabbit.
The story helps you remember the order. It does not replace practice. For the full steps and the checks to make before you load the knot, see the bowline guide.
Common mix-ups
- The rabbit goes around the wrong side of the tree. The result is a different knot, which can loosen or capsize under load.
- The rabbit goes back down the wrong opening. It should return down the same loop it came up through.
- Skipping the set. A knot that has not been snugged can work loose.
The idiom
Outside knot tying, “going down the rabbit hole” is a metaphor for being pulled into a long chain of unrelated topics, often while researching something. The phrase comes from Lewis Carroll’s Alice’s Adventures in Wonderland. That meaning is separate from the knot, and this page is about the knot.
Related knots
- The yosemite bowline is a bowline with an extra finishing tuck.
- The bowline on a bight makes two loops from one rope.