Short answer
A rope does not have one weight it can hold. Its strength depends on the material, the construction, the diameter, its condition, how it is tied, and how the load is applied. The number to look for is the rope maker’s rating. Check the breaking strength and the working load limit for the rope you have, and use them for the specific job.
Breaking strength
Breaking strength is the load at which a new rope fails when tested under controlled conditions. Makers test rope in a straight line, with the load applied steadily, and report the result. It is sometimes called minimum breaking strength or tensile strength.
A breaking strength is a test result for a new rope in ideal conditions. It is not a safe load for daily use. Real use involves knots, bends, wear, age and sudden loads, all of which reduce the strength the rope can deliver.
Working load limit and the safety factor
The working load limit (WLL), sometimes called safe working load, is the maximum load a rope should carry in service. It is a fraction of the breaking strength. The fraction is a safety factor, and it depends on how the rope will be used and on the standard that applies.
Do not assume a fixed factor. Some rigging guides use a larger safety factor than a casual user might expect, and the right factor depends on the job. The maker’s rating for the specific rope is the figure to use. If the maker gives only a breaking strength, ask them for the working load limit or get qualified advice before you use the rope on a load.
What lowers a rope’s strength
Several things reduce the strength a rope can deliver:
- Knots and bends: Any sharp bend cuts strength. Knots are a common cause of loss. For the comparison with splices, see is a splice stronger than a knot.
- Wear and abrasion: Rubbing over rough edges cuts fibers. Dirt works into the rope and acts like an abrasive.
- UV light: Sun exposure weakens many fibers over time, and the damage can be hidden inside the rope.
- Moisture: Natural fibers absorb water and can rot. Some synthetics absorb less, but water still affects them.
- Chemicals: Acids, fuel, and some cleaning products can weaken fibers. Acid contact is especially damaging.
- Heat: Friction or heat can melt or harden synthetic fibers.
- Age: Fibers deteriorate with time, even in storage. See when to replace rope.
Shock loads
A shock load is a sudden jolt, such as a jerk, a drop or a fall. A shock load can put far more force on a rope and its connections than the static weight of the load. The same weight picked up slowly and steadily is much easier on the rope. Avoid jerking a loaded line, and be careful about any sudden stop.
Load angle and multiple legs
When a load hangs from two or more legs of rope, the angle between the legs changes the force in each leg. The wider the angle, the more force each leg carries. A load that looks light can produce large forces in each leg at a wide angle. Keep the angle narrow where you can, and allow for it when you read the rating.
Reading a rope label or spec sheet
Look for these items on the label or the maker’s data sheet:
- Material: The fiber name, such as polyester or manila.
- Diameter and construction: The rope’s size, and whether it is three-strand, braided or another construction.
- Breaking strength: The maker’s test figure for new rope.
- Working load limit: The maker’s rating for service use.
- Date and standards: The manufacture date, and any standards the rope meets.
If the label does not give the rating you need, do not guess. Contact the maker, or do not use the rope for a load that matters.
Safety: climbing, rigging, lifting and anything with people
Rope strength is a serious subject. A rating applies only to the rope it was made for, in the condition and use the maker specifies. A rope rated for one job is not automatically rated for another.
For climbing, rigging, lifting, towing, and anything that carries people or overhead loads, use the maker’s data and applicable standards, and get qualified guidance before you rely on the rope. Do not use general rules of thumb for these jobs. For the signs that a rope should be retired, see when to replace rope. For the fiber comparison, see types of natural fiber rope and how to choose one.