The constrictor knot is a binding knot that tightens as you pull on its ends. It looks much like a clove hitch, but it has one extra pass that locks the turns in place. It is quick to tie and easy to release, which makes it useful for temporary binding. It is not a fastening to rely on for the long term.
How to tie a constrictor knot
- Lay the working end across the front of the object to make the first crossing.
- Take the working end down past the outside of that first pass, then straight behind the object.
- Bring the working end back around the front, from below, so it crosses the first pass and forms an X.
- Pass the working end under the starting line and up through the middle of the X.
- Pull the working end and the standing part in opposite directions. The X tightens onto the object, and the extra pass holds the knot.
Before you pull hard, check for the extra pass. The working end should run under the starting line. If the knot looks like a plain clove hitch with two turns and no extra pass, undo it and try again.
What it is good for
- Binding a bundle of poles, dowels or sticks, where the pull tightens the grip.
- Holding a line end temporarily while you work on it. Riggers sometimes use it in place of tape to keep a line from fraying during a splice.
- Jobs where a square knot would be the usual choice but you need the tie to hold more firmly. The square knot is fine for light work; for a tighter grip, the constrictor is the better pick.
For a flat, quick tie for light binding, see the square knot guide. For the neck of a sack, the Miller’s knot is the traditional choice.
Constrictor knot vs. clove hitch and square knot
- Clove hitch: two turns around the object, with no extra pass. The constrictor adds that one extra pass under the starting line. The pass twists the rope into a section held by the X, which makes the knot easy to tighten when both ends are pulled and helps it hold when the tension is released.
- Square knot: a flat knot for light binding. It is not the knot to choose when the tie has to grip round objects tightly.
For sticks, firewood and other bundles, a bundling knot gives you more leverage to cinch the load.
Releasing it and its limits
The constrictor knot is easy to release, which is useful, but it also means it is not a permanent knot. If the load goes slack or moves, the knot can loosen. Don’t rely on it to hold something in place for a long time.
To release it, ease off the tension and loosen the crossing with a finger or a marlinspike. Then work the working end back out of the knot.
Common mistakes
- Skipping the extra pass. Without it, you have a clove hitch, which locks differently.
- Pulling on one end only. Pull the working end and the standing part evenly to seat the knot.
- Using it as a permanent fix. It is designed to release easily.
- Using smooth or stiff line. Line with more grip holds the knot better. Test the tie before you rely on it.
Safety note
Do not use a constrictor knot to lift or hold people, to rig climbing or lifting gear, or for any load where a slip could cause injury. For those jobs, learn the method from a qualified instructor and use rated equipment. Test any knot with a gentle load before you trust it.