A trucker’s hitch is a tension hitch, not a binding knot. It lets you pull a line tight over a load so the load stays put, using a pulley-like loop in the line. People use it to cinch down cargo, tighten a ridgeline and hold gear in place. For road cargo, rated tie-down equipment should be the main securement, and a knot like this one is not a substitute for it.
How it works
The loop in the line acts as a pulley. In theory it gives about 2 to 1 mechanical advantage, so you pull with roughly half the force the line carries. In practice, friction at the anchors and in the loop reduces the gain.
What you need
- A line strong enough for the load, with some grip
- Two anchor points: one to tie the standing end to, and one for the line to run around on the far side of the load
- A secure knot for the first anchor. A bowline works well.
How to tie a trucker’s hitch
- Anchor the standing end. Tie the standing end to the first anchor point with a secure knot, such as a bowline.
- Run the line over the load. Take the line across the load and around the second anchor point on the far side.
- Make a slip loop. Form a loop in the line between the load and the far anchor. Pull a bight (a folded section) from the anchor side through that loop to make a slip knot.
- Thread the working end. Thread the working end up through the slip loop, then pull down on it. The loop acts as the pulley, and the load tightens.
- Lock it off. Pinch the loop to hold the tension, then tie two half hitches, or a halter hitch, around the load-bearing line just below the loop.
Once the lock is on, check that the line is tight and that the lock sits below the loop, not on it.
How to release it
Undo the half hitches first. Then ease the loop slowly to release the tension. Loads under tension can move when released, so stand clear and release a little at a time.
Common mistakes
- No lock. Without the half hitches, the tension can slip back.
- Sharp edges. A line that runs over a sharp edge can cut or chafe. Use edge protection.
- Standing in the line’s path. Keep your body and face out of the line while you pull.
- Worn line. Check the line for cuts, wear and UV damage before you use it.
Securing cargo on a vehicle
- Use rated tie-down straps or chains as the main securement for road cargo, and check your local load-securement rules.
- Check the tension after the first short drive, and again at stops.
- Do not exceed the rated working load of any strap, chain or anchor.
Other uses
Trucker’s hitches are also used on camp ridgelines and tarps, where a knot tensions a line between two anchors. For a bundle of sticks, a bundling knot is simpler. For a line that has to grip another rope under load, see the rolling hitch.
Safety note
Never use a trucker’s hitch to lift people or to hold a load overhead. Do not rely on rope alone for a load that could injure someone if it moved. Inspect the line before each use, and replace any line that shows damage.