Binding Knots and Hitches

How do you tie a bundling knot?

Learn how to tie a bundling knot to cinch sticks, firewood or brush: the loop, the wrap, the cinch and the lock, plus tips for longer bundles.

On this page
  1. How to tie a bundling knot
  2. Longer bundles: use two loops
  3. Choosing the line
  4. Common mistakes
  5. When to use a trucker’s hitch instead
  6. Safety note

To tie a bundling knot, make a loop at one end of the line, wrap the line around the bundle, thread the working end up through the loop, pull down to cinch the bundle, and lock the knot with a small loop and a second wrap. It suits sticks, firewood and brush, where you need to pull a bundle tight for carrying.

How to tie a bundling knot

  1. Make the loop. Tie a simple overhand loop at one end of the line. This gives you a fixed eye on one side of the bundle.
  2. Pass the line around the bundle. Lay the line under or around the stack, so the free end runs around the whole bundle.
  3. Thread the working end. Bring the working end up and through the loop you made.
  4. Cinch. Pull the working end down through the loop and pull firmly. The loop gives you leverage to draw the bundle tight.
  5. Lock it. Pinch the line where it crosses itself, pull a small loop through, and tighten it down. For extra security, wrap the remaining line around the bundle a second time before you tuck or tie it off.

Before you finish the lock, check the bundle. Each wrap should be snug, and the lock should sit against the bundle, not on top of the wraps.

Longer bundles: use two loops

For a bundle longer than about 2 to 3 feet (roughly 60 to 90 cm), many people advise tying two separate loops, one near each end. This helps stop the middle from sagging or loosening. The advice comes from online knot communities rather than a single authority, so use your judgment for the bundle in front of you.

Choosing the line

Use a line strong enough for the bundle’s weight, with some grip. Natural fiber rope and polypropylene twine suit most bundles. Smooth synthetic line can slip, so test the lock before you move the bundle.

Common mistakes

  • Pulling before locking. Make the lock first, then take up the slack.
  • Too few wraps. If the lock slides, add a wrap before you cinch again.
  • One loop on a long bundle. Use two loops, one near each end.
  • Skipping the test. Lift the bundle a short way and check that it holds before you carry it farther.

When to use a trucker’s hitch instead

A bundling knot holds a bundle together. It is not a tie-down for a load on a vehicle. For a load that must stay secure while a vehicle moves, use a trucker’s hitch with rated straps where you can. For a light bundle that only needs closing, a square knot may be enough.

Safety note

Do not lift or carry a bundle beyond what you can handle safely. Check that the line is rated for the weight. Keep your hands clear of the line while you cinch it, because a loaded line can snap back.

The complete guide to binding knots and hitches

Square Knot (Reef Knot): How to Tie It and When to Use It
Read the guide

Keep exploring

Guides from other topics

All topics →