Binding Knots and Hitches

Cleat Hitch: How to Secure a Line on a Cleat

Learn how to tie a cleat hitch to secure a boat line on a dock, with the base turn, figure-eight turns and locking hitch, plus how to release it.

On this page
  1. The parts of a cleat
  2. How to tie a cleat hitch
  3. How to release it
  4. Common mistakes
  5. Safety around loaded lines
  6. When to add turns
  7. Safety note

A cleat hitch secures a line to a cleat on a boat or a dock. Done properly, it holds the line under load and can be released quickly. The tie has three parts: a base turn, figure-eight turns around the horns, and a locking hitch that holds everything in place.

The parts of a cleat

  • Horns: the two arms of the cleat that the line wraps around.
  • Base: the bottom of the cleat, where the first turn goes.
  • Standing part: the line that runs to the load, such as the boat or a halyard.
  • Working end: the free end you tie with.

The load pulls on the standing part. Tie the hitch so the strain goes onto the base of the cleat.

How to tie a cleat hitch

  1. Base turn. Take the line around the base of the cleat, on the side away from the pull. This puts the strain on the base.
  2. First horn: figure eight. Bring the line across the top of the cleat and around the opposite horn.
  3. Second horn: cross over. Bring the line diagonally across the center of the cleat to the first horn, going around it and under it.
  4. Locking hitch. On the final pass, make a loop or an under-turn so the working end comes out from under the line.
  5. Cinch down. Drop the locking loop over the horn so it locks against the earlier turns. The working end should point back in the same general direction as the standing part.
  6. Neaten. Coil any spare line and place it on the deck or dock, where it cannot become a tripping hazard.

A finished cleat hitch sits neat and tight, with the turns lying flat against the cleat and the locking hitch holding them. If the turns can slide, untie it and start again.

How to release it

Lift the locking hitch off the horn first. Then unwind the turns in reverse order. Keep the line under control as you do this, because the boat or the load may still be pulling on it.

Common mistakes

  • Skipping the base turn. The base turn puts the strain where the cleat is strongest, so leaving it out weakens the tie.
  • A loose locking hitch. The final hitch holds the tie. Make it snug.
  • Too few turns for a heavy load. Add turns for heavier loads, and stay within the cleat’s rating.
  • Tying with slack in the line. Take up the slack first, then tie the hitch.

Safety around loaded lines

A line under load can snap back if it parts, and it can jump if it slips. Keep your hands, fingers and body out of the bight, and stand to the side of the line while you tie or release the hitch. Wear gloves if the line is rough or wet.

When to add turns

In strong wind or with a heavy boat, you may want more turns, a second cleat hitch, or a spring line to share the load. Check the lines regularly as conditions change.

Safety note

A cleat hitch is only as good as the cleat and the line. Check that the cleat is firmly fixed and rated for the load, and inspect the line for chafe where it runs over an edge. Do not stand in the line’s path when the load changes.

The complete guide to binding knots and hitches

Square Knot (Reef Knot): How to Tie It and When to Use It
Read the guide

Keep exploring

Guides from other topics

All topics →