Decorative Knots

Snake Knot: Step-by-Step Instructions

Follow step-by-step snake knot instructions for paracord bracelets, key fobs and lanyards, with cord length tips, even spacing and a clean finish.

On this page
  1. What the snake knot is
  2. Materials and cord length
  3. Tie the first section
  4. Flip and repeat
  5. Finish the knot
  6. Common mistakes
  7. A note on diagrams

What the snake knot is

The snake knot is a decorative paracord knot. It is used on bracelets, key fobs, lanyards and some macramé pieces. Repeated sections build up a rounded, textured band.

It is a decorative knot. Use it for looks and grip, not for a load.

Materials and cord length

  • Paracord: Nylon paracord is the usual choice. Two colours help you see the pattern as you work.
  • Scissors and a lighter for sealing the ends.
  • A key ring or loop if the knot will hang from something.

No single cord length works for every project. Measure the piece you want, then tie a short sample first. Note how much cord the sample used per centimetre, and scale up from there. Plan some extra cord for the finish.

Tie the first section

  1. Prepare the cord. Take two cords, or fold one long cord in half to make a loop at the top.
  2. Make the first loop. Wrap the left cord over or around the right cord to make a loop.
  3. Pass through. Take the right cord under the left cord, then down through the loop from top to back.
  4. Cinch. Pull both ends gently to tighten the first section.

Flip and repeat

  1. Flip the work over. Loosen the loop on the opposite side slightly. Take that working cord, pass it under and around, and thread it down through the loop.
  2. Alternate sides. Flip and repeat until the piece reaches the length you need. Keep each section the same size as the one before.

Finish the knot

Secure the last section with a finishing knot. A simple overhand knot works, and so does a diamond knot. For a diamond finish, see the lanyard knot guide. Pull the finish snug, trim the tails, and seal nylon ends with heat.

Common mistakes

  • Uneven sections. Pull each section to the same snugness before you flip the work.
  • A twisted band. Turn the work over regularly, so the cord does not spiral.
  • Loose sections. Snug each section before you start the next one, or the gaps will show.
  • Wrong over-under order. Undo back to the last clean section. Do not force the cord into place.

A note on diagrams

Snake knot sources describe the steps in different ways. If a step here does not match the diagram you are using, trust the diagram for the knot you are making, and check each section as you go.

For a flat weave with a square-knot pattern, see the cobra knot guide. To learn more about the name, see do snakes accidentally tie themselves in knots?. For an overview of craft knots, see decorative knots and knot tying crafts.

The complete guide to decorative knots

Decorative Knots and Knot Tying Crafts: Paracord and Rope Projects
Read the guide

Keep exploring

Guides from other topics

All topics →