Decorative Knots

Matthew Walker Knot: How to Tie a Lanyard Stopper

Learn how to tie a Matthew Walker knot, a multi-strand stopper for lanyards and rope ends, with tape prep, the order of passes and common mistakes to avoid.

On this page
  1. What a Matthew Walker knot does
  2. Prepare the strands
  3. Tie the loops
  4. Cinch the knot strand by strand
  5. Common mistakes
  6. Finish the ends

What a Matthew Walker knot does

A Matthew Walker knot is a decorative stopper. It keeps the end of a rope, or a bundle of cords, from unravelling. On working rope, whipping or heat sealing does the same job without the knob. It also forms a solid knob at the end of a lanyard or zipper pull.

It is a stopper, not a load-bearing knot. Its job is to finish the end neatly and stop it from fraying. It does not replace a secure attachment for anything that must hold weight.

Prepare the strands

  1. Measure about 6 to 8 inches (15 to 20 cm) from the end of the rope or cord.
  2. Wrap masking tape at that mark to stop the rope from unravelling while you work.
  3. Untwist the strands down to the tape, or separate the cords so each strand is free to move.

Paracord can be worked as a whole cord or with its inner strands separated. Practise with two strands before you move on to more.

Tie the loops

Each strand makes one loop around the bundle and passes through the loops made by the strands before it. The rule that helps most is simple: keep each new loop underneath the one before it, and tuck it through the loops below.

  1. First strand: Take it around the bundle, then pass it back through its own loop.
  2. Second strand: Take it around the bundle, through the first loop, and back through its own loop.
  3. Each further strand: Go around the bundle and pass through every earlier loop. Keep each new loop under the one before it.

Cinch the knot strand by strand

Do not pull the whole knot tight at once. Work strand by strand, sliding each loop down into a neat spiral. Pull each working end a little at a time, until the spiral sits tight against the standing part. Remove the tape once the shape is right.

Common mistakes

  • A messy blob. The loops have gone in the wrong order, so they pile up instead of forming a spiral. Undo back to the first loop, and check that each new loop sits under the one before it.
  • Uneven loops. Pull each loop to the same size as the one before it. Loops that differ in size make the spiral lopsided.
  • Too many strands too soon. With three or more strands, many people struggle at first. Practise with two strands until the loop order feels natural.

Finish the ends

When the knot is tight, remove the tape. Trim the tails, and melt the ends if they are nylon. Tuck any short tails under the knot where the design allows.

For another stopper for a lanyard, see the lanyard knot guide. For a weighted end, see the monkey’s fist guide. For an overview of knot crafts, see decorative knots and knot tying crafts.

The complete guide to decorative knots

Decorative Knots and Knot Tying Crafts: Paracord and Rope Projects
Read the guide

Keep exploring

Guides from other topics

All topics →