What a coiled rope bowl is
A coiled rope bowl is a flat spiral of rope, stitched together round by round. As the coil grows, the edge lifts and forms the sides of a bowl. People use coiled bowls for storage, for bread and fruit, and as covers for plant pots.
Choose the rope: sisal or cotton
Sisal is a stiff natural fibre. It holds a shape well, which suits a bold, sturdy bowl. It is also rough. It can irritate skin during long sessions, and it is harder on needles and sewing machines.
Cotton rope, around 5 to 6 mm thick, is softer, grips well and is easier to stitch. A sewing guide for rope bowls recommends cotton for a bowl that keeps its shape and can be washed by hand.
- Sisal: Stiff and holds shape well. Wear gloves for long sessions. Best stitched by hand with waxed thread and a strong needle.
- Cotton, around 5 to 6 mm: Softer and easier to stitch. Hand-wash it and dry it in shape.
- Synthetic rope: Avoid it. It dulls needles quickly.
Tools and materials
- Rope (sisal or cotton, as above)
- Waxed thread for hand stitching, or all-purpose thread for machine sewing
- A strong needle: a large, sharp needle for hand sewing, or a jeans or leather needle for a machine
- Clips to hold the coil while you sew
- Scissors, a ruler, and tape for joins
Make the flat base
- Start with a tight coil. Wind the rope into a flat spiral for a few turns, and hold it with a clip.
- Stitch the coil as you go. For hand stitching, make small, even stitches through the coil you are working and the one below it. Keep the stitches the same distance apart.
- Keep the coil flat. Let the rope glide through your fingers, and do not hold it tight. A tight rope makes the base arch.
For a sewing machine, use a zigzag stitch over the coil. A walking foot can help the coil feed evenly. Sew slowly, and check the base often to keep it flat.
Build up the sides
As the coil grows, the edge begins to lift. Keep the stitches even and the tension steady. A flat base lifts gradually into a bowl. A pulled rope makes the base arch instead. Large bowls take longer for the edge to form, so keep working at an even pace.
Join a new length and finish the rim
When a rope runs out, join the new length:
- Wrap the ends of both pieces with tape.
- Cut both ends at the same diagonal angle, so the cut faces fit together.
- Place the ends together and stitch over the join, then carry on.
- Remove the tape once the join is stitched into the coil.
To finish the rim, stitch the last few centimetres of rope firmly to the coil below. Trim the tail and tuck it in.
Fix common problems
- The base arches. Ease off the tension and let the rope glide. On a machine, check the stitch width and the presser foot pressure.
- The edge will not curve. Keep going. Large bowls take longer to form their sides.
- The needle breaks or skips. A bent or worn needle skips straight stitches. Replace it with a stronger one.
- Open gaps. Stitch back over the gap with a few extra stitches to close it.
Care
Hand-wash cotton bowls and shape them while they are damp. Dry them in shape, away from direct heat, and do not put them in a tumble dryer.
For cord choices for other rope crafts, see the macramé cord guide. For a different rope craft with knots, see the macramé knots guide. For an overview of knot crafts, see decorative knots and knot tying crafts.