What a fishtail bracelet looks like
A fishtail bracelet has a braided look. It is made by weaving cords over and under one another along a core. The pattern repeats, so once you have the rhythm, the weave moves quickly. It is a popular first project because you can change colours easily and the result looks more complex than it is.
Supplies and cord length
- Paracord: One, two or four colours
- A heat source for sealing the ends, such as a lighter or a small butane torch
- Scissors
- A bracelet jig (optional), which holds the work steady
The core should be your wrist length plus about a foot (about 30 cm) for the finish. Measure your wrist with a flexible tape or a piece of string, then add the finishing allowance. Make a short sample first to check the length.
Start with a lark’s head knot on a core
- Fold a cord in half and tie a lark’s head knot around a second cord, or a clip.
- Split the cords into two groups. The two cords on the right become the core. The two cords on the left are the weaving cords.
- Keep the core straight and at the length you measured, with the weaving cords hanging free.
Weave the fishtail
The weave works by taking each weaving cord over one cord and under the next, then under and over again, so each row locks into the one before.
- Take the outer left cord over the first core cord, then under the next.
- Take the outer right cord under the first core cord, then over the next.
- Pull each row snug as you go, so the weave lies flat.
- Repeat the rows until the bracelet reaches the length you need.
Check the weave every few rows. Each cord should lie flat with no gaps, and the pattern should match the rows before. If you are unsure of the order, a demonstration video can help you check the over-under sequence.
Change colours
Start a new colour by tying it onto the end of a weaving cord with a lark’s head knot, then keep weaving with the new colour. Tuck the old end under the weave so it does not show. Keep the tension the same as the rest of the bracelet.
Finish the bracelet
When the bracelet reaches the right length, finish it with a secure knot. A lanyard or diamond-style finish works well. For that method, see the lanyard knot guide. You can also add a buckle. Trim the tails and melt the nylon ends with a lighter.
Common problems
- A twisted weave. The cords have turned. Turn the work and check each row.
- Uneven tension. One side is pulled tighter than the other. Pull each row evenly.
- Gaps in the weave. A cord has skipped a stitch. Undo a few rows and redo them.
For another paracord bracelet with a flat weave, see the cobra knot guide. For an overview of knot crafts, see decorative knots and knot tying crafts.