What Chinese knotting is
Chinese knotting is a tradition of decorative cord knots. They are often used as ornaments, charms, closures and gifts. Many knots are built from a few basic moves, and the same knot can be made in different sizes and colours.
Knots often have symbolic names. The meanings can differ by knot and by region, so check a reliable source before you give a knot as a gift with a specific meaning.
What to use: cord, tools and finishing
- Cord: Satin cord and nylon paracord are easy starting points, especially in red or another bright colour. Traditional knotters also use silk and rattail cord.
- Length: The good luck knot described here uses about 1 metre (about 3 feet) of cord. The button knot uses about 60 to 70 cm. Add a little extra for the tails.
- Tools: Scissors, a pin or clip to hold the knot while you shape it, and a lighter to seal nylon ends.
- Finishing: Trim the tails, seal nylon ends with heat, and tuck the tails into the knot where you can.
Melt nylon carefully in a ventilated space, and keep the flame away from hair, clothing and other materials.
Make a good luck knot
The good luck knot (also called the auspicious knot) is built from a central square with loops on each side.
- Fold the cord in half to find the centre, and form the top loop.
- Measure about 10 cm (4 inches) down from the top loop, and form a matching loop on the left and right sides.
- Fold the bottom loose strands up and over the left loop. Fold the left loop over the bottom strands. Fold the top loop down over both, leaving a small opening at the bottom.
- Take the right loop through the opening at the bottom.
- Repeat in reverse on the other side. Take the left loop over the bottom loop, bring the bottom loop up and across, and tuck the free strands through the small opening.
- Tighten and shape. Pull gently on all the loops and tails, pull the small tags to form the ear loops, and square up the centre.
Traditional instructions vary. If a step does not match what you see, loosen the knot and check a diagram before you go on.
Make a button knot
The button knot, also called the lotus bud knot, is compact and rounded. It is often used as a closure or on a keyring.
- Take a cord of about 60 to 70 cm (24 to 28 inches). Form a loop with a crossing, and flip it down to make two overlapping loops.
- Place the right loop over the left loop. Wrap the working cord around your thumb and behind the knot.
- Thread the working cord up the left side, down through the middle, and up through the right loop.
- Remove your thumb. Guide the cord down through the centre, and pull the slack out slowly to shape a diamond or ball.
Keep the knot loose until the weave holds, then tighten in small steps. Pulling hard too early distorts the shape.
Other traditional knots readers ask about
- The good luck knot: the square knot shown above.
- The button knot: the compact closure shown above.
- The endless knot (pan chang): a knot with no visible start or end, often shown among auspicious symbols.
Many more traditional knots exist. Check a reliable guide for the name and meaning of any knot before you use it.
Tips for even knots and neat ends
- Work on a flat surface and clip the pieces you are not working on.
- Pull each pass snug, but not hard, or the knot will bunch.
- Check symmetry at each stage. A mirror helps you see the shape from the front.
- For natural cords, a small dab of clear glue can secure the tails. Let it dry fully before you trim.
For a wider look at knot crafts, see decorative knots and knot tying crafts.