What a sennit is
A sennit is a braid made from several cords or strands, worked in a repeating pattern. Sennits come in two main shapes. A flat sennit lies in one plane, like a ribbon. A round sennit forms a tube. Flat sennits are common in lanyards, bracelets and decorative bands.
Materials and cord choice
- Cord: Nylon paracord is easy to work and its ends can be sealed with heat. Cotton cord is softer but needs more care to keep the tension even.
- Strands: The more strands you use, the wider the braid and the more cord you need. Start with three or four strands.
- A way to hold the top end: A clip, a clamp or a hook keeps the braid steady. Wrap the top with tape so the strands do not unlay.
- Scissors and a lighter for finishing nylon ends.
Plan the cord length
A braid gets shorter as you work it, because every pass takes up some length. A published guide for a 9-strand braid suggests cutting about 1.4 times the finished length, plus a little extra. More strands need more allowance.
Test with a short sample before you cut the real length. Measure how far the braid shortens, then scale up.
Make a simple flat sennit
The simplest flat sennit uses three strands. Work it as follows.
- Tape the top end. Lay the three strands side by side, flat.
- Take the left strand over the middle strand, so it becomes the middle.
- Take the right strand over the new middle strand.
- Repeat steps 2 and 3, alternating left and right. Keep the strands flat and the tension even.
- When the braid is long enough, tape or tie off the end and trim the tails.
Flat sennits with four or more strands follow a counted pattern. On each pass, a strand moves over and under a set number of other strands. Count each pass as you go, and check the pattern against a diagram. Keeping the odd strands in one hand helps you avoid mix-ups.
Fix mistakes early
- Lost count. Undo back to the last pass you are sure of. It is easier to fix a few passes than a whole braid.
- Crossed strands. A crossed strand leaves a gap or a bump that becomes more visible with each pass. Stop and fix it at once.
- Passes too loose or too tight. Tighten each pass, but do not jam it. Nylon tends to settle as you go. Cotton holds its lay less well, so keep each pass fairly firm from the start.
- Backing up. Pull the last pass out one piece at a time and lay it again. Do not force the braid back into shape.
Where flat sennits are used
Flat sennits suit lanyards, zipper pulls, bracelets and decorative bands. A finished sennit usually needs a stopper or finishing knot at each end. For one option, see the lanyard knot guide.
For an overview of other rope and cord crafts, see decorative knots and knot tying crafts. For a different flat weave, try the cobra knot.