What a Snell knot does
A Snell knot attaches your line to the shank of a hook, not to the eye. The line then pulls straight from the hook point, which some anglers say helps set the hook.
When it fits
Many guides use the Snell with straight-shank hooks, and some anglers use it when fishing bait or working heavy cover. If your hook has a large eye or a lure has its own eyelet, an eye-tied knot is often simpler. See the Palomar knot guide.
What you need
- Line of your choice.
- A hook with a clear eye.
- Water or saliva to wet the knot.
- Clippers to trim the tag.
Step by step
- Thread from the front. Pass the line through the eye of the hook from the top, the front side, not the back.
- Lay the line along the shank. Run the line down the hook shank, then curl the tag end back to form a loop.
- Pinch. Hold the shank and the parallel lines together between your thumb and finger, near the bend.
- Wrap the shank. Wrap the tag end around the shank and the main line, working back toward the eye. Make 5 to 7 wraps for mono or fluorocarbon, or 8 to 10 for braid or heavy cover. Keep the wraps tight and not overlapping.
- Lock it. Pass the tag end back through the loop you formed in step 2, so the wraps lock in place.
- Wet and cinch. Moisten the knot. Pull the main line and the tag end gently so the coils compact neatly.
- Slide and trim. Slide the finished knot flush against the back of the eye, then trim the tag close.
Wrap counts
- Mono or fluorocarbon: 5 to 7 wraps.
- Braid or heavy cover: 8 to 10 wraps. Braid is slick, so more wraps help the knot hold.
Common mistakes
- Threading from the back of the eye. One guide says this creates a reverse Snell and lowers the hook-up rate. Thread from the front.
- Loose wraps that do not sit neatly against each other.
- Dry cinching, which adds friction and heat.
- Skipping the tug test before you fish.
Hook safety while tying
Hooks are sharp. Hold the hook with pliers or a hook holder rather than your fingertips, and keep the point away from your fingers while you cinch. Trim the tag with clippers, not your teeth.
Snell or Palomar?
Use a Snell when you want the line attached to the hook shank. Use a Palomar when you are tying to a lure or a hook with an eye you can pass a loop through. Both are covered in our Palomar knot guide, and for the mono comparison, see our strongest monofilament knots guide.