The bimini twist is a loop made from a doubled line. You twist the two strands together, then lock the twists with half hitches. It is used when you need a strong loop on a main line, most often for heavy offshore fishing or a loop-to-loop leader. It takes more time and room to tie than most loops, so practice it before you need it.
What the bimini twist does
The bimini twist gives you two parallel strands of line running from a single loop. Because the line is doubled, the loop can be used as a connection point for a leader or a swivel. Anglers choose it for heavy line and big fish, where a simple loop may not be enough.
When to use it
- Heavy saltwater fishing, where the line and fish are large
- A loop-to-loop connection to a leader
- Situations where you want a loop that stays put under load
It is not a quick knot. For a faster loop on lighter line, see fishing loop knots.
What you need
- Enough line for the loop and the working length. A longer loop needs more line.
- A way to hold the loop under tension, such as a helper, a fixed point, or your knee.
- Practice line of similar strength so you can run through the steps first.
- Gloves, if the line is heavy and you will be pulling hard.
How to tie it
- Double the line into a loop. Leave enough of the open ends to work with.
- Make about 20 twists in the end of the loop, keeping the twists tight and even.
- Hold the loop under tension. Slip the open end over your knee, or over both knees or your feet for a longer loop, and keep steady pressure on both ends.
- Roll the tag down the twists. Lower the hand that holds the tag end until the tag slips back over the first twists. Open the angle of the loop and let the tag roll down the column of twists to the far end.
- Lock with a half hitch. Once the tag reaches the end of the twists, tie a half hitch on the near side of the loop. Keep tension on all the lines.
- Finish with half hitches. Tie 3 to 5 half hitches around both lines of the loop, working from the loop end back toward the knot. Snug each one against the base of the knot.
- Trim the tag to about 1/4 inch.
Finishing half hitches
The half hitches do the locking, so take your time with them. Tighten each one firmly against the one before it. Loose hitches let the twists unwind, which weakens the loop.
Common mistakes
- Uneven twists. Uneven twisting makes the column lumpy and harder to roll.
- Losing tension. If the loop is not held taut, the twists can pull apart as you work.
- Rolling the tag too early. Let the tag travel the full length of the twists before locking.
- Skipping the half hitches. Without them, the twist is not locked in place.
Safety under tension
Heavy line under load can snap and whip back. Keep your hands, face and body clear of the line when it is under tension. Hold the loop in a stable setup, and do not wrap the line around your body. If you are not sure the setup is safe, do not pull hard on it.
Practice before you use it
Run through the steps on a short length of scrap line first. Once you can tie it cleanly, give the finished loop a firm pull. If the twists creep or the half hitches shift, adjust the tension and tie it again. Then check the loop before every trip.
For a broader view of loops, see fishing loop knots. For the braid connections that often pair with a loop, read knots to join two fishing lines together.