What a dropper loop does
A dropper loop puts a loop in the middle of a line, standing out at a right angle. Like the alpine butterfly in rope, it makes a fixed loop without using either end of the line. You can attach an extra hook, fly or sinker to it. Anglers use it on leaders and tippets for an extra fly, and on multi-hook bottom rigs.
When to use one
- Adding a second hook or fly partway along the line.
- Building a bottom rig with several hooks or a sinker.
- Adding an extra fly to a leader or tippet.
Another way to add a dropper is to leave one tag end long when you join two lines with a surgeon’s knot.
What you need
- Enough line to make a loop. Keep it short, as explained below.
- Water or saliva to wet the line.
- Your fingers or pliers to hold the loop while you cinch.
Step by step
- Form a loop. Make a loop in the line where you want the dropper to sit.
- Pinch and twist. Pinch where the two strands cross, then twist the two parallel strands around each other 5 to 6 times. Use fewer twists on thick line and more on thin line (see the table below).
- Open the centre. Keep a gap open in the middle of the twists, so you can pass the loop through it.
- Pass the loop through. Take the bottom of the original loop and push it up through the centre gap.
- Wet and cinch. Wet the line. Hold the protruding loop with your fingers or pliers, and pull both main lines evenly to tighten the coils.
- Check the shape. The dropper should look almost symmetrical on either side of the loop.
Twist counts by line size
| Line | Twists |
|---|---|
| Thick line | About 4 |
| Standard line | 5 to 6 |
| Thin line | 6 to 8 |
These counts vary a little between sources, so treat them as starting points and check the knot on your own line.
Keep the loop short
A dropper loop should not be too long. A long loop raises the risk of fouling and twisting. A short loop also stands away from the line, which helps avoid tangles.
Attach a hook or sinker
Attach a hook or sinker to the loop with a knot you trust, such as the improved clinch or the Palomar. For loop knots used elsewhere in your rig, see fishing loop knots.
Common mistakes
- Loops that are too long, which tangle easily.
- Uneven twists, which leave the coils lopsided.
- Letting the centre gap close before you pass the loop through.
- Cinching dry line, which adds friction and heat.
- Pulling one end only, which skews the knot.
Check before you fish
Pull both main lines evenly, then tug the loop. The loop should hold its shape and not slide. If it slips or looks lopsided, retie it. For braid to a leader in the same rig, see braid to leader knots.