Fishing Knots

How do you tie the strongest fishing knot?

The Palomar is the knot most often called the strongest fishing knot. Here is why it holds, how to tie it correctly, and when to choose a different knot.

On this page
  1. The short answer
  2. Why the Palomar is the usual pick
  3. How to tie it
  4. When another knot is better
  5. What makes any knot strong
  6. Common mistakes

The short answer

The Palomar is the fishing knot most often called the strongest, and it is a reliable choice for tying line to a hook, lure or swivel. It works with braid, mono and fluorocarbon. Sources quote its strength at roughly 85 to 95 percent of the line’s rating, but those figures come from different tests, so treat them as a guide. How well you tie the knot matters as much as which knot you pick.

Why the Palomar is the usual pick

The Palomar uses a doubled line. You pass the loop through the eye, tie an overhand knot with it, then pass the hook through the loop and tighten. The tightened knot holds the hook securely, and according to Animated Knots, a widely used reference, it leaves the hook free to rotate. With practice, it can be tied in low light.

The main drawback is that the hook or lure has to pass through the loop, so the loop must be large enough.

How to tie it

  1. Double the line. Fold about 6 to 12 inches of line into a loop.
  2. Pass the loop through the eye. Push the folded loop through the eye of the hook, lure or swivel.
  3. Tie a loose overhand knot. With the loop, tie a simple overhand knot around the standing line and the tag end. Keep the hook hanging outside, and do not tighten it yet.
  4. Pass the hook through. Open the loop wide and pass the whole hook or lure through it.
  5. Wet and cinch. Wet the knot. Pull the standing line and the tag end evenly to tighten it.
  6. Trim. Cut the tag end, leaving about 1/8 to 1/4 inch.

Guides differ on where the final knot should sit. Some slide it up against the eye. Animated Knots describes tightening the loop around the line below the eye, which lets the hook turn, and says most experienced anglers prefer that version. Either way, pull evenly and test before you fish.

When another knot is better

  • Large lure or heavy hook. A big lure can be hard to pass through the loop. The improved uni, sometimes called the Fish-N-Fool knot, is a common alternative. See our uni knot guide.
  • Joining two lines. The Palomar is for hooks and lures, not for line-to-line joins. For those, see braid to leader knots.
  • Light line and small hooks. The improved clinch is a classic option. See how to tie the improved clinch.

What makes any knot strong

  • Wet the knot before you tighten it. Friction from dry line creates heat that can weaken it.
  • Pull slowly and evenly. Tugging one end can leave the knot lopsided.
  • Keep the coils neat. Crossed or loose coils weaken the knot.
  • Trim close, but not too close. Leave a small tail so the tag cannot slip out.
  • Test before every fish. A firm tug takes a second and can save a fish.

Common mistakes

  • Tying with dry line, so the line heats up as you cinch it.
  • Pulling only one end, which leaves the knot uneven.
  • Forcing a large lure through a small loop.
  • Skipping the final tug test.

For step-by-step instructions on the Palomar, see our Palomar knot guide.

The complete guide to fishing knots

Fishing Knots for Braided Line: The Best and Strongest Options
Read the guide

Keep exploring

Guides from other topics

All topics →