What the uni knot is
The uni knot is a versatile fishing knot for attaching line to a hook, lure or swivel. Some guides call it the Duncan or Grinner knot. It works on mono and fluorocarbon, and with more wraps, on braid. It is also the single-line building block of the double uni, which joins two lines.
When to use it
- Tying to hooks, lures and swivels when you want one knot for most terminal tackle.
- Retying in the field, because the knot is adjustable and easy to slide into place.
For joining two lines, use the double uni instead. See braid to leader knots or knots to join two fishing lines.
Step by step
- Thread the eye. Pass the line through the eye of the hook, lure or swivel, and pull through about 8 to 10 inches of tag.
- Form a loop. Lay the tag end back alongside the standing line, and bring it back toward the eye to make a wide loop.
- Pass the tag through the loop. Take the tag end up through the loop, then wrap it around both the standing line and the tag end.
- Complete the wraps. Make 5 to 6 wraps for standard mono or fluorocarbon. Use 3 to 4 for heavy line, or 7 to 8 for lighter line.
- Snug the coils. Gently pull the tag end to close the coils. At this point the loop forms a slip knot, which is what lets the knot slide.
- Wet the knot. Use saliva or water to reduce friction.
- Slide and tighten. Pull the standing line to slide the knot down against the eye.
- Trim. Cut the tag end close to the knot.
Wrap counts by line type
| Line | Wraps |
|---|---|
| Heavy mono or fluorocarbon | 3 to 4 |
| Standard mono or fluorocarbon | 5 to 6 |
| Light mono or fluorocarbon | 7 to 8 |
| Braid | More than 10 |
Wrap counts vary between sources, so use these as starting ranges and test the knot. The braid figure comes from one guide that says “more than ten.”
Uni knot for braid
Braid is slick, so the uni needs more wraps to hold. Some guides also pass the tag through the eye a second time, which makes a modified uni, sometimes called the Fishing Fool knot. The Palomar knot is another common choice for braid. For loops rather than hook ties, see fishing loop knots.
Double uni for joining two lines
The double uni is two uni knots, one on each line, slid together. It works best when the two lines are close in size, and it is a good way to join braid to a leader.
Common mistakes
- Too few wraps, so the knot can slip under load.
- Cinching dry line, which adds friction and heat.
- Pulling the loop instead of the standing line when you slide the knot down.
- Skipping the test. Give the finished knot a firm pull before you fish.
Test before you fish
Give the finished knot a firm pull. If it slides or the coils look uneven, retie it from the start.