Most people tie a standard bow, and it works well on everyday shoes. It can work loose on slippery laces, though, and a heel that lifts inside the shoe causes rubbing. This guide covers a correctly tied standard bow, two alternative knots that hold better, and the runner’s loop, which locks the heel in place.
Start with a correct square bow
Many shoes come undone because the bow was tied as a granny knot, with both crossings going the same way. A square (reef) knot reverses the second crossing, which keeps the bow balanced.
- Cross the laces and pull them tight. Pass the left lace over the right, then under and through the gap.
- Make a loop with each lace, one in each hand.
- Cross the loops the opposite way to the first crossing: right over left, then under and through the gap.
- Pull both loops, and tighten the bow evenly.
If the bow lies on its side or one loop is much bigger than the other, you have probably tied a granny knot. Undo it and start again.
Ian’s secure shoelace knot
Ian’s secure knot is a fast, symmetrical bow. Both loops pass through the same central opening, which creates a double wrap that grips the laces. Many runners use it, and it is often recommended for slippery round laces. Ian Fieggen’s shoelace site has illustrated steps. Practice on a pair of shoes you wear at home before you rely on it, because the steps are easy to mix up at first.
The surgeon’s knot
The surgeon’s knot starts with a double wrap instead of a single crossing. Cross the laces, wrap them around each other a second time, and pull tight before you finish the bow. The extra turn adds friction, so the knot suits boots, work shoes, and laces that slide. It is a little harder to untie than a standard bow.
The runner’s loop (heel lock)
The runner’s loop, also called a heel lock, keeps your heel from lifting inside the shoe. It uses the top pair of eyelets, so the shoe needs a spare eyelet above the last crossing.
- Lace normally up to the second-to-last pair of eyelets.
- For the top pair, feed the left lace down through the top eyelet on the left side, from the outside. A small loop forms inside the shoe.
- Do the same with the right lace on the right side.
- Cross the laces. Pass the left end through the right loop, and the right end through the left loop.
- Pull both ends down and outward to snug the collar around your heel.
- Tie a standard bow.
If your heel still lifts after this, the shoe may be too big for your foot, and no lacing method fully fixes that.
Which method to use
| Method | Best for | Trade-off |
|---|---|---|
| Square bow, tied correctly | Everyday shoes | Can work loose on slippery laces |
| Ian’s secure knot | Running, and round laces that slip | Takes a little practice |
| Surgeon’s knot | Boots, work shoes, slick laces | Harder to untie |
| Runner’s loop | Heel slip | Needs a spare top eyelet |
Tips for laces that stay tied
- Waxed or textured flat laces grip better than slick round synthetic laces.
- Tighten the crossing first, then pull the loops evenly. Yanking the loops can collapse the bow.
- Match lace length to your number of eyelets. Laces that are too short will not form a bow, and laces that are too long drag and snag.
Frequently asked questions
Which shoelace knot is the most secure?
No single knot wins for every shoe. For most people, a square bow tied correctly works well. Use a surgeon’s knot or Ian’s secure knot if the bow keeps loosening, and add a runner’s loop if your heel slips.
What if I cannot untie a knot?
Work the knot loose a little at a time with a pick or a blunt tool, rather than pulling harder. Our guide to untying a tight knot covers the methods.
Can I tie shoelaces with one hand?
Yes. Our one-handed knots guide explains methods for when one hand is busy.