Rope and Ropework

Coiling Rope: How to Coil and Store Line Without Kinks

Reduce kinks and tangles. Learn the standard, over-under, flat and butterfly coils, plus how to store line so it stays usable and ready to run.

On this page
  1. Short answer
  2. Why rope kinks and tangles
  3. What you need
  4. Standard coil: coil with the lay
  5. Over-under coil
  6. Flemish (flat) coil
  7. Butterfly coil
  8. Storage
  9. Common mistakes
  10. Quick checklist

Short answer

Rope kinks when twist builds up in it or when it is set into bends it does not want to keep. The main fixes are to coil in the direction the rope already turns, to alternate loop direction when the rope is twisted, to lay line flat for deck use, and to store it dry and loosely. Coiling will not remove all twist. Rope needs use and time to settle.

Why rope kinks and tangles

  • Twist: Three-strand (laid) rope carries built-in twist. Coiling against that twist adds more, and the rope kinks.
  • Set: Rope that has been stored tight, or hung from one point for a long time, can hold bends. Those bends become kinks.
  • Dirt and moisture: Wet or dirty rope clings to itself and tangles.
  • Braided rope: It kinks less than three-strand rope, but careless coiling or tight storage can still form loops.

What you need

  • A clean, dry surface, or a helper to hold the far end.
  • Gloves for rough or fibrous rope.
  • A hook, peg or rope bag for storage. See the storage section below.

Standard coil: coil with the lay

Look at the end of the rope to see its lay, the direction the strands spiral. Coil the rope in that same direction, so each loop turns the way the rope already turns. This keeps twist from building up in the coil.

  1. Hold the rope in your coiling hand, with the working end you want to start from.
  2. Make loops of an even size, roughly the span of your hand and arm.
  3. Lay each loop over the last so the coil stacks neatly.
  4. Keep the loops even and the coil tidy as you go.
  5. Finish by tying off the coil with a short piece of line, or by hanging it.

If a coil tangles as you make it, stop and lay the rope out flat, then start again.

Over-under coil

An over-under coil alternates the direction of each loop. Make one loop over your hand, then the next under it, and continue the pattern. Each loop turns the rope the opposite way, which cancels the twist.

The over-under coil is useful for three-strand rope that has built up twist, and for working lines that tend to kink as you pay them out. It takes a little practice to keep the loops even.

Flemish (flat) coil

For deck lines, mooring lines and other lines that need to run freely, lay the rope in a flat coil. Start with the working end in the middle, then lay each loop beside the last, spiraling outward, so the coil lies flat on the deck. When the rope is laid out this way, it pays out from the center without tangling.

Butterfly coil

The butterfly coil is widely used for long climbing ropes. It forms a bundle that pays out from the top without tangling, and it is finished with a tie-off. The tie-off and the handling matter for safe use, so learn them from a qualified instructor and do not rely on written steps alone.

Storage

  • Keep it dry. Let wet rope air-dry fully before you store it. Do not seal damp rope in a bag.
  • Keep it cool and shaded. Store it out of direct sunlight, which weakens many fibers over time.
  • Keep it away from chemicals. Fuel, batteries, fertilizers and cleaning products can damage rope, so store rope apart from them.
  • Keep it loose. Hang coils on hooks or pegs, or store them in a bag or box that lets air move. Avoid tight bends and heavy weight on the coil.
  • Inspect as you go. Check the rope each time you handle it. For the signs that mean it should be retired, see when to replace rope.

Common mistakes

  • Coiling wet rope into a bag. Mold and mildew follow.
  • Coiling against the lay. This adds twist and causes kinks.
  • Hanging the rope from one point for a long time. Long hanging can set bends into it.
  • Storing near heat, fuel or battery acid. Heat and chemicals weaken fibers.
  • Ignoring the ends. A frayed end snags when you pay out the line. Finish the ends so they stay tidy. See how to finish rope ends.

Quick checklist

  • Dry the rope before storing it.
  • Coil in the direction of the lay.
  • Use the over-under coil for twisted rope.
  • Use a flat coil for deck and mooring lines.
  • Store the rope out of sun and away from chemicals.
  • Inspect the rope every time you handle it.

For natural fiber rope in particular, storage matters more, because it rots when it stays damp. See types of natural fiber rope and how to choose one.

The complete guide to rope and ropework

Types of Natural Fiber Rope and How to Choose One
Read the guide

Keep exploring

Guides from other topics

All topics →